Menú

Adda

Lime based paint

Slaked lime based paint recommended for historical buildings, made with traditional raw materials and following antique processing methods. The product permits to obtain aesthetical and chromatic effects depending on hand-made application.

Features:

– anti-molds

– anti-bacteria

– high vapor permeability

– excellent adhesion and durability.


Information

Fields of application

Recommended  for outdoor and indoor:

  • For historical and high esteem buildings restoration.
  • For decoration of walls and facades, made of mineral plasters.
  • For architectural restoration and recover, as it features aesthetical effects very close to traditional lime based paints.
On new wall surfaces

Remove dust, dirt and oil traces from surfaces. Let plasters cure for 28 days at least, before proceeding with Adda application.

On old wall surfaces or patched with old paint

Remove any paint, fungus and mold traces. Proceed to a deep cleaning of the surface, preferably with a pressure washer. The surface must be clean and totally dry. If necessary, seal cracks or smooth using Renovo mortars.

Finishing

Apply two coats of the product conveniently diluted, with at least a 12 hours gap between them, using a sufficiently soft brush or roller to reduce application traces. It is possible to complete the cycle, applying through swab or natural sponge, the lime based veiling Scialbatura.

Reccomendations

Do not add any binding agents, inerts or other materials to the product. Do not apply it in windy days or in rain forecast, do not apply on hot surfaces, under direct sunlight, use adequate protection devices (windbreakers, sunshieldings). Do not apply with temperatures lower than +10°C or higher than +35°C and humidity >75%. Protect the surfaces from rain for at least 48 hours. Apply on cured supports.

Because of natural raw materials, color variation may occur among production batches. To avoid color differences, large surfaces must be worked with product from the same batch. Avoid the application of the material on the same surface on different times and weather conditions, because this could cause color variations. It is recommended to fetch the material in one batch.

Protect eyes during application and in case of contact, wash with water. Refer to safety sheet for further details.

Technical Data

Application

brush - roller

Packs

l 4 - l 13

Colour

white - pastel color

Density

approx. 1.35 kg/l

Dilution by volume

approx. 30-40% with water

Drying

dryed: 5-6 h - hardened: 8-12 hr

Coverage

excellent

Water vapor transmission rate

Class V1 - high (Sd <0,14 m - EN ISO 7783-2)

Gloss

Class G3 - matt (<10% - EN ISO 2813)

Dirt pick-up

ΔL< 3 (UNI 10792)

Theoretical Yield

approx. 6-7 sqm/l for coat

Tools cleaning

water soon after use

VOC

< 30 g/l (2010) - Cat. a: matt coatings for interior walls and ceilings - water-base (Dir. 2004/42/CE)

Pallet

33 drums of L 13

Data contained in technical data sheets refer to laboratory tests. Indications and methods may be subject to change over time, depending on any technological and productive improvements. Products application takes place out of our control, as we cannot directly intervene on the conditions of the construction sites and on the execution of the works. All indications are general and do not bind our company in any way and therefore the responsibility falls exclusively on customer. We recommend a preventive test of the product in order to verify the suitability in relation to its particular use. Technical service is available to provide additional information.

Do you want to know how many Adda packs you need?

Calculate it now

surface to be covered in square meters