Menú

Chirafug F – G – GG

One-component cementitious mortar for grouting joints

One-component cementitious mortar for grouting joints, consisting of special cements, redispersible polymers, graded aggregates, admixtures and special pigments.
Availaibility:
– Chirafug F: for joints from 0 to 2 mm
– Chirafug G: for joints from 2 to 15 mm
– Chirafug GG: for joints larger than 15 mm


Information

Fields of application

Thanks to high hardness, good mechanical strength, smooth finishing and low water absorbency, Chirafug is suitable for grouting: interior/exterior floors and walls, all types of ceramic tile, marbles and natural stones, areas subject to intense traffic.

Applicazione

The joints must be dry clean, free of dust; the excess adhesive or mortar should be removed while still fresh.
Fill the joints well using a trowel or rubber float, making sure the joints are completely compacted with no unevenness; remove excess grout, while still fresh, from the surface moving the trowel or float diagonally across the joints. Clean excess product with a damp hard cellulose sponge working diagonally to joints using clean water only and avoid emptying the joints.
In the case of grouting porous coatings, it is necessary to carry out a preliminary test to verify cleanability and if necessary apply a protective treatment on the surface.

Recommendations

Never mix Chirafug with brackish or dirty water. The amount of mixing water must be always the same, in order to avoid uneven colors. Use the product at temperature between +5°C and +35°C. The substrate must be perfectly dry, adequately protected from rising damp in order to avoid efflorescence or uneven color. The chart colors are indicative, variations in color may occur depending on the environmental conditions and the method of application. Do not apply in walls or floors where specific chemical resistances are required, in case of flexible joints or on substrates that are highly deformable.

Compliance

Technical Data

Application

rubber trowel - sealant gun

Packs

kg 5 - kg 25

Mixing water

ca. 30-40%

Water absorption

after 30 minutes < 2 g - after 4 hours < 5 g

Colour

chart colors

Consumption

varies for sizes and spacers

Cleaning diluent

water immediately after use

Drying

varies according to joints thickness, complete after 15 days

Density of the mix

2 kg/dm³

Ready for use

7 days

Set to light foot traffic

after 24 hours

pot life

90 min

Compressive strength

> 30 MPa

Flexural strength

> 5 MPa

Shrinkage

< 2mm/m

Mix standing times

approx. 15 min

Box:

4 bags of kg 5

Data contained in technical data sheets refer to laboratory tests. Indications and methods may be subject to change over time, depending on any technological and productive improvements. Products application takes place out of our control, as we cannot directly intervene on the conditions of the construction sites and on the execution of the works. All indications are general and do not bind our company in any way and therefore the responsibility falls exclusively on customer. We recommend a preventive test of the product in order to verify the suitability in relation to its particular use. Technical service is available to provide additional information.

Secured By miniOrange