Ideal, thanks to its high grade of vapor trasmittance and low water absorption, in environments where a dehumidifing cycle is required.

Applicable on any type of indoor support, properly prepared:

• Smoothing products
• Consistent paints and coatings
• Fine plasters
• Gypsum surfaces and plasterboards
• Supports subjected to resanation cycles

On old walls: Proceed to consolidation and resanation of the support with specific products depending on the surface condition. Before proceeding to finishing, make sure the support is perfectly dry and cured.

On new walls: Sand and dust out perfectly.

Pre-treated walls: Sand and dust out if in good conditions. In bad conditions, carefully remove any previous detaching paint, fill any possible hole and crack, let dry, sand and dust out perfectly.

Apply, properly diluted, with a roller, brush or spray waiting 4-5 hours between coats.

Do not apply on wet or not-cured supports. Do not apply below 5°C or above 35°C. Use clean water for dilution. It is recommended to protect from dust until complete drying. Maximum washability is achieved after 15 days from application.