Menú

Drywall Rinzaffo

Thermal scratch coat

Scratch mortar to enhance adhesion on lightened thermo-insulating cement plasters, based on Portland cement, lime, selected granulometry carbonate inerts and addictives which enhance adhesion and workability. Applicable by and or machinery, enhances adhesion of plasters on the support.


Information

Fields of application

Used as scratch coat on indoor/outdoor masonries such as:

  • Bricks
  • Tuff
  • Stone
  • Concrete
Support preparation

Substrate must be perfectly solid, free from duest, dirt, failing parts and efflorescences. Clean the surfaces by sanding or sandblasting, then wash with pressurized water to remove any residue.

In the presence of efflorescences or salts, proceed by washing with low pressurized water. In the case of salt excess, treat the support with an efflorescences inhibitor (see SalMur).

Wet the support before application and wait the superficial water to evaporate.

Mixture Preparation

To apply by hand, pour in a container the right amount of water to mix a bag of Drywall Rinzaffo, add gradually the powder and mix with a low-rounds stirrer or cement mixer until an even, clump-free mixture is achieved. Let rest for 5 minutes and stir briefly before usage.

To apply via machinery, use a PFT plastering machine, adjusting the flow-meter to obtain a thixotropic consistency.

Application

Apply by hand with a trowel or plastering machine, covering evenly the surface for a total thickness of 4-5mm. Let cure for at least 24 hours before applying the plaster.

Recommendations

Use clean, non-brackish water. Apply between 5°C and 35°C. Do not apply in high sun exposure and on rainy/windy days. Protect from rain, wind, sun and rapid desiccation for 24-48 hours after application. In case of application during summer, ensure a constant desiccation by using Sunshieldings/Windbreakers. Do not add materials, cement or other bonding agents in the bag. It is recommended to mix the entire content of the bag in one solution.

 

Compliance

Technical Data

Application

flat trowel - plastering machine

Packs

kg 25

Colour

grey

Mixing water

approx. 5-6 l per bag

Maximum diameter of aggregate

< 2,5 mm - EN 1015-1

Consumption

approx. 4 kg/sqm

applicable thickness

5 mm

Application temperature

from +5°C to +35°C

Workability time

approx. 60 min

Adhesion

> 0,3 N/mm² - A - EN 1015-12

Water absorption

class W0 - EN 1015-18

Coefficient of permeability to water vapour µ

< 12 - EN 1015-19

Thermal conductivity

0,53 W/m K - tabulated value according to EN 1745

density of hardened mortar

1,5 kg/dm³ - EN 1015-10

density of fresh mortar

1,8 kg/dm³ - EN 1015-6

Compressive strength

classe CS III - EN 1015-11

Reaction to fire

Euroclass A1 - EN 13501-1

Durability

NPD

Subsequent products

after 24 hr

Storage

max 6 months in dry place

Tools cleaning

water soon after use

Pallet

60 bags of kg 25

Data contained in technical data sheets refer to laboratory tests. Indications and methods may be subject to change over time, depending on any technological and productive improvements. Products application takes place out of our control, as we cannot directly intervene on the conditions of the construction sites and on the execution of the works. All indications are general and do not bind our company in any way and therefore the responsibility falls exclusively on customer. We recommend a preventive test of the product in order to verify the suitability in relation to its particular use. Technical service is available to provide additional information.

Secured By miniOrange