Menú

Drywall

Thermal plaster with polystyrene beads

Premixed thermo-insulating plaster composed by cement, selected mineral inerts, expanded polystyrene beads, polymeric fibers and addictives. Thanks to its formula, the product is very light and low thermal conducting. Suitable for outdoor/indoor wall plastering in thermo-insulating systems.


Information

Fields of application

Drywall is used for the realization of thermo-insulating systems, particularly on irregular walls where sheet based insulation systems are not applicable.

Support preparation

Supports must be consistent, free from dust. Oils and dirt must be removed in advance. A few days before application, treat the concrete parts with a cement scratch-coat. Guides must be realized with the same material. Edges and openings must be covered with guards.

Mixture Preparation

To apply by hand, mix with a cement mixer or a low-rounds stirrer, adding to the content of a 50 L bag 7,5 L of clean water (given the nature of the product, it is recommended to mix the content of the bag in one solution). Stir for 5-10 minutes. If necessary, wet the support a few hours before treatment.

To apply via plastering machine, use a elical mixer with solid screw, stator specific for lightweight mortars, long-pitched screws and 14mm diameter nozzle.

Application

Apply by hand with a trowel or via plastering machine. Apply the next coat while the previous coat started to grip. Level with an aluminum stadia while avoiding to compress the product. On brick/cls joints it is recommended to apply anti-alkali fiberglass meshes.

Once hardened, the surface must be scratched with an appropriate robot. Thickness must be between 3cm and 12cm. After 28 days from application, once hardened, apply two coats of RasaPro Flex, inserting an anti-alkali fiberglass mesh between coats. Once the smoothing product has cured, it will be possible to apply the decorative finish coating.

Recommendations

Apply between 10°C and 30°C. Do not apply on risk of rain or in windy days. Do not apply on gypsum based supports.

Compliance

rt

Technical Data

Application

flat trowel - plastering machine

Packs

l 50

Colour

grey

Mixing water

approx. 7.5 l per bag

Yield

3.6 sqm/bag per cm of thickness

Maximum diameter of aggregate

2 mm

Thermal conductivity

λ : 0.053 W/m K

Density of the mix

0.20 kg/dm³

density of fresh mortar

0.37 kg/dm³

Coefficient of permeability to water vapour µ

9

Compressive strength

class CSI

applicable thickness

3 - 12 cm

Drying

28 days per 4 cm of thickness

Tools cleaning

water soon after use

Storage

6 months in dry place

Packaging

30 bags of L 50

Data contained in technical data sheets refer to laboratory tests. Indications and methods may be subject to change over time, depending on any technological and productive improvements. Products application takes place out of our control, as we cannot directly intervene on the conditions of the construction sites and on the execution of the works. All indications are general and do not bind our company in any way and therefore the responsibility falls exclusively on customer. We recommend a preventive test of the product in order to verify the suitability in relation to its particular use. Technical service is available to provide additional information.

Do you want to know how many Drywall packs you need?

Calculate it now

surface to be covered in square meters











Secured By miniOrange